Tutorial: Tank Servicing and Troubleshooting

Welcome to MistHub’s Help guide to Tank Maintenance and Troubleshooting. Will probably like discuss the way to perform routine maintenance on your tank atomizers to keep them functioning in top condition. We’ll also review some common problems as well as their solutions. First, let’s examine how to properly utilize a brand-new tank or perhaps a new coil you merely set up in your tank.

If you purchase a new coil you’ll want to make sure that you prime it before deploying it. Priming a coil will ensure that the wick within it is saturated with e-juice before its first use. This substantially lowers the potential for burning your wick or damaging your coil. To prime your coil you’ll want to place 4-5 drops of e-juice straight into the coil head. Install the coil head by threading it into the tank’s base. You could then fill and assemble your tank. For best results you must wait 5-10 minutes before its first use. If you are on the go and cannot wait the 5-10 minutes you should a minimum of wait 1-2 minutes, close the airflow and take several deep pulls without firing your device. You should be able to then re-open the airflow and make use of the tank normally without issue.

Whilst it may seem like a complex task to maintain your tank properly it really is fairly simple. To start with you will want to ensure that it stays clean. One or more times per month clean your tank. Start by taking out the coil(s) as well as any O-rings. While detaching the O-rings search for signs of wear or any cracks. In the event the any O-rings are damaged, replace them. Clean your tank thoroughly using isopropyl alcohol or domestic hot water as well as a mild dish soap on the lining and out. Make sure you pay special awareness of the threads (a classic toothbrush may help because of this part). Make sure to wash your O-rings too. Rinse it well, then rinse it again in order to be certain there’s no soap or residue left out. As soon as your uwell is very dry you are ready to reassemble and use it again.
The most common issue tank users are presented with is leaks. A leaky tank could be a real inconvenience but typically they’re relatively simple to fix. 99 percent of times an army tank is leaking because it is letting air in somewhere which breaks the vacuum that holds your e-liquid from the tank. First, consider the tank apart inspecting all glass or plastic parts searching for any cracks. If you don’t see any, look at the O-rings for warning signs of damage or cracks. If any of the aforementioned mentioned parts are damaged in any respect replace them if required. Make sure you check and make certain the coil head itself is fully threaded into place but isn’t overly tight. It must be easily removable without the use of tools. If it is too tight it could have damaged the O-ring(s) on the base from the coil or pushed them unnatural. If your O-rings for the coil are damaged replace them or even the entire coil. In the event the tank is constantly on the leak and every one of the above mentioned has been checked it can possibly be in connection with a poor coil head. Over time via use the wicking materials can break up and not hold as much juice because they once did. This causes a lack of surface tension allowing air to sneak in from the coil in which case it should be changed.
To read more about uwell explore this site: click here