Tutorial: Tank Servicing and Troubleshooting

Here you are at MistHub’s Help guide Tank Maintenance and Troubleshooting. Here we will discuss how to perform routine maintenance on your tank atomizers to make sure they’re functioning in good shape. We’re going to also talk about some common problems as well as their solutions. First, let’s examine the way to properly work with a fresh tank or perhaps a new coil you just placed in your tank.

Whenever you purchase a new coil you will need to make certain you prime it before using it. Priming a coil will make sure that the wick inside it is saturated with e-juice just before its first use. This substantially lowers the potential for burning your wick or damaging your coil. To prime your coil you will want to place 4-5 drops of e-juice straight into the coil head. Install the coil head by threading it in the tank’s base. You’ll then fill and assemble your tank. For the most powerful results you should wait 5-10 minutes before its first use. Should you be on the go and will not wait the 5-10 minutes you need to at least wait 1-2 minutes, close the airflow and take several deep pulls without firing your device. You need to be capable of then re-open the flow of air and use the tank normally without issue.

Whilst it may seem as being a complex task to maintain your tank properly it is in reality very easy. First and foremost you’ll want to ensure that is stays clean. At least one time 30 days clean your tank. Begin by detaching the coil(s) and then for any O-rings. While removing the O-rings seek out signs of wear or any cracks. If your any O-rings are damaged, replace them. Clean your tank thoroughly using isopropyl alcohol or hot water plus a mild dish soap on the within and out. Make sure you pay special care about the threads (an old toothbrush may help with this part). Be sure to wash your O-rings too. Rinse it away, then rinse it again simply to be certain there is no soap or residue left behind. As soon as your uwell is completely dry you are ready to reassemble and employ it again.
The most frequent issue tank users are faced with is leaks. A leaky tank could be a real inconvenience but typically they’re relatively easy to repair. Ninety nine percent almost daily a fish tank is leaking since it is letting air in somewhere which breaks the vacuum that holds your e-liquid from the tank. First, consider the tank apart inspecting all glass or plastic parts looking for any cracks. Should you not no matter what, confirm the O-rings for signs and symptoms of damage or cracks. Or no of the above mentioned parts are damaged in any way replace them when needed. Be sure you check and ensure the coil head is fully threaded into place however is not overly tight. It should be easily removable without having to use tools. If it is too tight it could have damaged the O-ring(s) on the bottom in the coil or pushed them homeless. If the O-rings on the coil are damaged replace them or the entire coil. If the tank will continue to leak causing all of the aforementioned continues to be checked it can possibly be in connection with a bad coil head. Over time and throughout utilize the wicking materials can break down and not hold all the juice while they used to. This causes an absence of surface tension allowing air to sneak in from the coil in that case it must be changed.
To learn more about ijoy have a look at our new web portal: check