Tips On How To Use Carbide Burs

Carbide burrs are tools utilized for deburring most hard materials like ceramics, stone, steel, aluminum, plastics and hardwood. They offer precision, and will also be used in cutting, shaping, grinding and chamfering hard materials.

Carbide burrs works extremely well on the various materials including metals (including Steel aluminum and iron) and forms of wood. You can use it on acrylics, fiberglass and plastics too. Carbide burrs will last for a long time without chipping or breaking to ensure it’s so great for their services on soft metals like gold,platinum and silver.

Do you know the Attributes of Carbide Burrs In contrast to HSS Burrs?

Weighed against HSS, Carbide Burrs are much harder.

The Tungsten Carbide is very hard in order to provide in wider range of work than HSS (Very fast Steel).

HSS can’t be as good as carbide burrs when they’re at warm. Carbide Burrs can bear hotness and can run longer time.

Carbide won’t soften at warm but HSS burrs is opposite. There is no doubt that carbide is a better choice.

Using Carbide Burs:

For additional stability, insert the accessory bit into the tool and then back it out slightly before tightening on the collet nut or keyless chuck.

Do not use these for drilling holes or enlarging holes that are below twice the diameter with the cutter. The tungsten carbide surface can easily catch the side of the hole and break the bit.

Use higher speeds for hardwoods, slower speeds for metals and slow speeds for plastics (to avoid melting at contact point).

Start at a lower speed. Then increase towards the speed that offers one of the most favourable results.

Do not apply excessive pressure. It might decrease the spindle and chip cutting edges. Let the bur carry out the cutting.

Utilize the sides with the cutter for effective cutting. The tip cuts poorly and will break under time limits.

Never in-capsulate the bur from the cut. If chattering occurs, increase speed.

When using aluminium and magnesium, consider some type of lubricant, wax or tallow, as it can help stop the flutes from loading or packing.

Carbide burs, if used the proper way, will outperform HSS burs by 50
More info about SD-51 Carbide Burrs go to see our webpage